Ruihan Precision Technology (Jiangsu) Co., Ltd. is located in Nantong City, Jiangsu Province, mainly producing 200-800 tube type strand rope machines and basket type rope closing machines.

Firstly, before taking over the shift, labor protection equipment must be worn neatly, arrive on duty in advance, hand over to the corresponding person, and it is not allowed to leave the post and cross over.

Secondly, the operator must be familiar with the functions and usage methods of all buttons on the control panel, as well as their operating procedures, and require concentration to prevent errors.

Thirdly, before driving, the driver must personally check the integrity of the equipment, whether the oil pressure, water pressure, and air pressure are normal. If any abnormalities are found, the driver is not allowed to drive and should promptly notify a dedicated person for maintenance.

Fourthly, it is strictly prohibited to place repair tools and other items on equipment (such as twisting machines, control consoles, etc.). To avoid accidents during device operation.

Fifthly, when driving, a dedicated person must be in charge of the control panel. If two people operate, they must cooperate and understand each other's signals before driving. If there are problems with the twisting part, they should be reported to the person in charge for maintenance in a timely manner and not allowed to start.

Sixth, when installing the I-shaped wheel, the operators need to cooperate with each other and place it correctly and smoothly into the basket. The operator should stand on the side to prevent accidents.

Seventh, after the I-shaped wheel is inserted into the basket, the operator should adjust the tip of the top in place and lock the spring pin shaft. When threading, two people should operate and cooperate with each other. Hold the head of the steel wire and lead it out from the wire reel frame. After passing through the guide wheel and passing through the wire mouth distribution reel along the outer edge of the rotor, gather and fasten it in front of the molding machine to prevent the steel wire from retracting and injuring people. Close the protective cover and lock the braking device.

The above is the correct operation and usage standard for the twisting machine, hoping to be helpful to you.

Eighth, if the interruption wire of the twisted steel wire is outside the distribution reel, the open steel wire should be wound around the steel wire and the head should be fixed so that it cannot be raised vertically. Track and observe whether it can pass smoothly on the outside, and stop the machine immediately if any problems are found.